Cautions

• The product is recommended for children over 4 years old.
• Do not allow children under 3 years old to use the product.
• An adult must be present when children use the product.
• Do not put the product at the edge of a high place to prevent damage by falling.
• Do not disassemble, repair, or modify the product yourself to prevent from the product failure.
• Battery is not replaceable.
• Do not put the product in water or fire, or expose it to a damp or high temperature environment to avoid product failure or safety hazards.
• Do not use or charge the product at a temperature exceeding the operating temperature range.
• Please fully charge the product before leaving it idle, and charge it at least once every 3 months.
• Please use the recommended adapter (5V/2A) to charge the product.
• The power adapter (not included in the product package) for the product is not a toy.
• Misuse of the power adapter might result in electric shock hazard.
• Please shut down and disconnect the product from the external power supply before cleaning the product with liquid.
• Do not connect the product to more than the recommended quantity of power supplies.
• This product could only be charged under adult’s supervision.
• Check the cables, plugs, casing, and other components for any damage on a regular basis. Stop using the product immediately if any damage occurs and get it repaired.
• The toy is only to be connected to Class II equipment bearing the following symbol ““.
• Faults may occur when the product is charged at a temperature lower than 0°C or higher than 40°C.

  Specifications

  | Battery (mTiny) | 1,800 mAh lithium battery | | —- | —- | | Micro USB input voltage (mTiny) | DC 5V | | Micro USB input current (mTiny) | 1.5 A | | Battery (tap pen controller) | 300 mAh lithium battery | | Micro USB input voltage (tap pen controller) | DC 5V | | Micro USB input current (tap pen controller) | 270 mA | | Transmission mode | 2.4G | | Frequency range | 2400 MHz–2480 MHz | | Working distance | Within a 10-meter radius (in an open field) | | Operating temperature | 0°C–40°C | | Storage temperature | –10°C–+55°C |

FCC STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

• This device may not cause harmful interference, and
• This device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

  FCC Radiation Exposure Statement

  This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

DECLARATION OF CONFORMITY

Declaration of conformity Hereby, Makeblock Co., Ltd., declares that this product is in compliance with the essential requirements and other relevant provisions of Directive RED 2014/53/EU and the RoHS directive 2011/65/EU