Upload timeouts

1.What should I do if there is a timeout in the process of Grove Zero burning?
The reason for the timeout of burning is complicated, among which the common reason is the abnormal appearance of the Main Board. In that case, user is required to reset the Main Board BLE manually. The specific operation method is as follows.
Step 1: Enter the boot mode, as shown in the figure below.
1) Disconnect the Main Board from both the USB cable and the battery module.
Troubleshooting - 图1
2) Press the reset button of the Main Board, hold it and connect the Main Board to the computer through the USB cable.
Troubleshooting - 图2
3)Keep pressing the reset button, wait for about 8 seconds, till the orange status light start to flash slowly. It indicates that it has entered boot mode.
Troubleshooting - 图3
Step 2: Update the firmware.
Please refer to 3.2 firmware update for detailed operation

Unable to connect to Apple systems

After connecting the main board to an Apple computer with an USB cable, once click on “connect”, the device to connect might not be found in the script area of Codecraft.
If it happens, it may be that your Apple computer system version is too low. Go to download the USB driver compressed file to your local, unzip it and install it. Then it may help you solve the problem.
Download the driver: https://pan.baidu.com/s/1FZgfubw-M43XsXcU3TUHMA
Code: 5wy7

circuit does not work

-Try to reset the circuit by clicking the reset button on the Control Board.
-Check the LED Indicator labeled ‘Status’ on your Control Board, see if it’s flashing slowly, if so, your Control Board might be running a different program, try to hold down the reset button for over 5s to restore its firmware.
-Check your battery, see if it is out of charge.
-Check your connections, make sure the magenetic connectors are aligned and the contacts are not shorted.

Update the Control Board

-Your Control Board may be updated in the future to support new features or the snap&play of the new Grove Zero modules.
-You can always check the firmware version of your Control Board and decide whether or not to update your Control Board to the latest version using Codecraft software.