Connect 安全性

Connect enables secure service-to-service communication over mutual TLS. This provides both in-transit data encryption as well as authorization. This page will document how to secure Connect. For a full security model reference, see the dedicated Consul security model page.

Connect will function in any Consul configuration. However, unless the checklist below is satisfied, Connect is not providing the security guarantees it was built for. The checklist below can be incrementally adopted towards full security if you prefer to operate in less secure models initially.

Warning: The checklist below should not be considered exhaustive. Please read and understand the Consul security model in depth to assess whether your deployment satisfies the security requirements of Consul.

核查表

ACLs Enabled with Default Deny

Consul must be configured to use ACLs with a default deny policy. This forces all requests to have explicit anonymous access or provide an ACL token. The configuration also forces all service-to-service communication to be explicitly whitelisted via an allow intention.

To learn how to enable ACLs, please see the guide on ACLs.

If ACLs are enabled but are in default allow mode, then services will be able to communicate by default. Additionally, if a proper anonymous token is not configured, this may allow anyone to edit intentions. We do not recommend this. If ACLs are not enabled, deny intentions will still be enforced, but anyone may edit intentions. This renders the security of the created intentions effectively useless.

TCP and UDP Encryption Enabled

TCP and UDP encryption must be enabled to prevent plaintext communication between Consul agents. At a minimum, verify_outgoing should be enabled to verify server authenticity with each server having a unique TLS certificate.verify_incoming provides additional agent verification, but doesn’t directly affect Connect since requests must also always contain a valid ACL token. Clients calling Consul APIs should be forced over encrypted connections.

See the Consul agent encryption page to learn more about configuring agent encryption.

If encryption is not enabled, a malicious actor can sniff network traffic or perform a man-in-the-middle attack to steal ACL tokens, always authorize connections, etc.

Prevent Unauthorized Access to the Config and Data Directories

The configuration and data directories of the Consul agent on both clients and servers should be protected from unauthorized access. This protection must be done outside of Consul via access control systems provided by your target operating system.

The full Consul security model explains the risk of unauthorized access for both client agents and server agents. In general, the blast radius of unauthorized access for client agent directories is much smaller than servers. However, both must be protected against unauthorized access.

Prevent Non-Connect Traffic to Services

For services that are using proxies (are not natively integrated), network access via their unencrypted listeners must be restricted to only the proxy. This requires at a minimum restricting the listener to bind to loopback only. More complex solutions may involve using network namespacing techniques provided by the underlying operating system.

For scenarios where multiple services are running on the same machine without isolation, these services must all be trusted. We call this the trusted multi-tenancy deployment model. Any service could theoretically connect to any other service via the loopback listener, bypassing Connect completely. In this scenario, all services must be trusted or isolation mechanisms must be used.

For developer or operator access to a service, we recommend using a local Connect proxy. This is documented in thedevelopment and debugging guide.

If non-proxy traffic can communicate with the service, this traffic will not be encrypted or authorized via Connect.